Research Outputs

Permanent URI for this communityhttps://hdl.handle.net/20.500.14288/2

Browse

Filters

20141

Advanced Search

Filter by

Settings

Department: search.filters.department.Department of Electrical and Electronics EngineeringSubject: search.filters.subject.Ceramics

Search Results

Now showing 1 - 1 of 1
  • Placeholder
    PublicationMetadata only
    Fabrication and gas sensing properties of C-doped and un-doped TiO2 nanotubes
    (Elsevier, 2014) Sennik, Erdem; Işık, Müge; Ahsen, Ali Şems; Öztürk, Osman; Öztürk, Zafer Ziya; Department of Electrical and Electronics Engineering; Kılınç, Necmettin; Researcher; Department of Electrical and Electronics Engineering; College of Engineering; 59959
    In this work, un-doped and carbon (C) doped TiO2 nanotubes were fabricated and their hydrogen sensing properties were investigated. A Ti foil was anodized in an aqueous hydrofluoric acid (H:F) electrolyte (0.5 wt%) at room temperature to form TiO2 nanotube arrays. C-doped TiO2 nanotubes were obtained through two methods; a chemical process and thermal acetylene (C2H2) treatment. In the chemical method, a Ti foil was anodized 'in-situ' in aqueous solution of 0.5 wt% polyvinyl alcohol (PVA)+0.5 wt% HF. In the heat treatment method, a Ti foil was anodized in an aqueous (HF) electrolyte (0.5 wt%) to obtain TiO2 nanotubes, and then C-doped TiO2 nanotubes were obtained by heating as-prepared nanotubes at 500 degrees C in a quartz tube under a continuous N-2 and C2H2 flux (1:1). The obtained un-doped and C-doped TiO2 nanotubes were characterized by scanning electron microscopy (SEM), energy dispersive X-ray analysis (EDX) and X-ray photoelectron spectroscopy (XPS). The H-2 sensing properties of the nanotubes exposed to 5000 ppm H-2 were investigated at 100 degrees C. C-doped TiO2 nanotubes showed a lower response to H-2 than the undoped TiO2 nanotubes.